Energy technology profile
Marine energy converters
Marine energy devices harvest motion or gradients in oceans and tidal waters. The atlas keeps this as a compact section focused on tidal-stream and wave systems.
Technical deep dive
How it works
Tidal-stream turbines extract energy from predictable currents using underwater rotors, while wave devices convert oscillating motion, pressure, or airflow into mechanical and then electrical power. Subsea cables carry the output ashore. The energetic environment also produces difficult loads, corrosion, biofouling, access constraints, and expensive installation and maintenance campaigns.
Tidal-stream energy
A tidal rotor extracts kinetic power approximately as P = ½ρAv³Cₚ, where seawater density ρ, swept area A, current speed v, and power coefficient Cₚ set the instantaneous mechanical output. Because power scales with the cube of velocity, small errors in site current or wake prediction cause large energy errors. Tidal timing is predictable, but peak magnitude, turbulence, blockage, and array wakes are site-specific.
Pitch or torque control keeps the rotor within structural and generator limits. A drivetrain and generator convert shaft power; converters regulate voltage and frequency; a wet-mate cable and subsea export system carry it ashore. Foundations, floating platforms, or moorings must resist cyclic loads and extreme currents while allowing retrieval for maintenance.
Wave-energy conversion
Ocean waves carry oscillatory energy in surface elevation, pressure, and particle motion. Point absorbers, oscillating water columns, attenuators, and overtopping devices couple different portions of that motion to a power take-off. Control can tune device velocity or force to the incoming spectrum, raising capture but also peak loads.
Wave resource is often stated in kilowatts per metre of wave crest, not as the device's electrical rating. Directional spreading, storm extremes, hydrodynamic resonance, mooring motion, generator efficiency, and availability determine annual output. Arrays also interact through radiated and diffracted waves.
Ocean engineering dominates lifetime performance
Saltwater corrosion, galvanic couples, seal wear, cable fatigue, biofouling, sediment, fishing activity, and limited weather windows affect every subsystem. Designing only for average seas produces failure; designing every part for the largest conceivable storm can make the device uneconomic. Survival modes, redundancy, remote condition monitoring, and rapid retrieval are therefore part of the energy technology.
Environmental assessment tracks collision risk, underwater sound, habitat change, electromagnetic fields from cables, and navigation. Many effects are local and design-specific, requiring measurements before and after deployment rather than assuming either zero impact or unacceptable impact for the whole category.
Reason to use it
What could make it valuable
Tides are highly predictable and some coastal wave resources complement the timing and geography of land-based generation.
Unresolved engineering
What still blocks it
Devices must produce enough lifetime energy to outweigh installation, subsea cabling, corrosion, biofouling, storm loading, and difficult offshore maintenance.
Predictable tides and energetic coastlines offer differentiated generation profiles, but survivability and lifetime energy cost are the core tests.
Monthly evidence layer
Research watch
Named programs, dated developments, and primary or official sources. Company claims are identified separately from independent or peer-reviewed evidence.
Last reviewed 6 September 2026
Research groups & programs
- U.S. DOE Water Power Technologies Office
Wave and tidal testing, materials, controls, resource characterization, and commercialization programs.
- PacWave South
Grid-connected open-ocean testing of wave-energy devices and arrays.
Current developments
Long-duration test frontier
Open-water campaigns are extending beyond short demonstrationsLonger deployments expose availability, cable, mooring, corrosion, control, and maintenance behavior that tank testing cannot reproduce.
Manufacturing frontier
Materials and installation choices are being designed togetherDOE reviews emphasize composites, coatings, generators, moorings, foundations, subsea connectors, and recoverability as coupled cost drivers.
Papers & official resources
- official resourceMarine Energy Basics
U.S. Department of Energy · official explainer
- technical reviewMaterials and manufacturing for marine energy
U.S. Department of Energy · 2022