← All energy systems

Energy technology profile

Next-generation photovoltaics

Next-generation photovoltaics use tandem junctions, perovskites, concentrated light, or other architectures to move beyond conventional single-junction modules.

  • tandem cells
  • perovskites
  • advanced solar

Technical deep dive

How it works

In a tandem cell, stacked absorber layers divide the solar spectrum: a wider-bandgap top cell captures higher-energy photons while a lower-bandgap cell uses light that passes through. Perovskite absorbers are attractive because their bandgap can be tuned and they can be deposited in thin layers. A module must preserve efficiency after encapsulation while surviving moisture, heat, ultraviolet light, electrical bias, and outdoor temperature cycles.

Why tandem absorbers raise the limit

A single junction loses sub-bandgap photons by transmission and turns photon energy above the bandgap into heat. A tandem stacks absorbers: a wide-bandgap top cell converts high-energy visible photons at high voltage, while lower-energy light reaches a narrower-bandgap bottom cell. The combined device reduces both loss channels and can exceed the single-junction Shockley–Queisser limit.

In a two-terminal monolithic tandem, the subcells are series connected through a recombination junction, so their currents must match and their voltages add. Spectrum, angle, temperature, optical thickness, parasitic absorption, and degradation can unbalance current. Four-terminal tandems relax matching but add transparent contacts, wiring, area, and module complexity.

Perovskite device physics

Metal-halide perovskites offer a tunable bandgap through composition and can be deposited as thin films. Charge-selective transport layers extract electrons and holes while suppressing recombination. Interfaces, grain boundaries, ion migration, defects, band alignment, and contact reactions control open-circuit voltage, fill factor, hysteresis, and long-term stability.

Composition that gives the desired wide bandgap can phase-separate under illumination. Moisture, oxygen, heat, ultraviolet light, and electrical bias can decompose layers or move ions. Encapsulation has to block those pathways while surviving outdoor thermal expansion and allowing scalable module interconnection.

Cell record versus energy product

Certified cell efficiency is measured under a standardized spectrum and aperture. Scaling introduces coating nonuniformity, shunts, dead interconnect area, resistive loss, and lower manufacturing yield. A module then needs bypass behavior, edge seals, glass, junction boxes, and safety qualification.

Lifetime energy yield depends on efficiency, spectral response, temperature coefficient, degradation rate, downtime, and local climate. Lead-containing absorbers also require robust containment, manufacturing controls, and end-of-life plans. A higher initial cell record does not by itself establish lower levelized cost.

Reason to use it

What could make it valuable

Tandem absorbers can capture different parts of the solar spectrum and generate more electricity from a limited roof or land area.

Unresolved engineering

What still blocks it

Laboratory efficiency must survive large-area coating, encapsulation, moisture, heat, ultraviolet exposure, electrical bias, and decades of field operation.

Tandems could produce more power from the same area, but stability, scalable manufacturing, material use, and bankable field data determine commercial value.

Monthly evidence layer

Research watch

Named programs, dated developments, and primary or official sources. Company claims are identified separately from independent or peer-reviewed evidence.

Last reviewed 6 September 2026

Research groups & programs

Current developments

  1. 2025 record

    Certified perovskite–silicon research cells approached 35%

    The result strengthens the area-efficiency case while leaving module size, yield, degradation, and cost to be demonstrated.

  2. Commercialization frontier

    Reliability evidence is moving to larger areas and longer tests

    The critical comparisons are stabilized efficiency, accelerated qualification, outdoor performance, encapsulation, and production yield—not a brief reverse-scan peak.

Papers & official resources